Publicidad
Idiomas disponibles
Idiomas disponibles
SEH 1800/1850
• Do not pull the cord with unnecessary force. Do not wrap
the cord around the unit. Check cord regularly for any
sign of damage. Damaged cords can be dangerous.
• Always switch the appliance off before putting it down,
even if it is only for a moment.
• Always unplug the appliance after use.
• Let the appliances get cold before store it.
• Do not introduce any metallic item in the airlet in order
to avoid an electric discharge.
• Do not put the air outcome too close the hair.
• The dryer must be installed away from areas where
people may be bathing or showering
• The appliance must be installed so that the portable part
when fully extended, is out of reach of a person who is
bathing or showering
DESCRIPTION
A. Stand
B. Switch ON/OFF
C. Speed knob
D. Temperature knob
E. Filter
INSTALLATION
To install the bracket, first unscrew the screw above the light, as can be seen in pic.
Remove the back of the stand, you see two holes in the top and one in the bottom
central side. Place this piece in the desired location for installation, it is recommended
you a nearby plug, check it and mark the position of the screws with a pencil or
marker through the holes in the rear piece.
Drill holes in the wall with a drill, insert the wall plugs (they are included) into the
hole. Place the bracket back on and screw these to the wall with the screws provided. Place the front of the
bracket on the back and place the first screw.
Direct connection
Once removed the first front cover, unscrew the screw placed near to switch (1) to remove next cover and
show the cabling. Inside, you can find a power strip, where you have to disconnect the cord to main network
(2) (to the plug).
9
Publicidad
