Functions - CBE PC150-EL Instrucciones De Uso

FUNCTIONS

CAR BATTERY ALARM (B1)
When car battery voltage gets under 12V, Motor Battery Discharge alarm goes on and the symbol ref. 10
starts blinking. Alarm goes off when the voltage gets over 12.5V.
LEISURE BATTERY ALARM (B2)
When leisure battery voltage gets 11.5V the Leisure Battery Reserve alarm goes automatically on, the
symbol ref. 08 starts blinking and you hear a short beep.
When the leisure battery voltage gets 10.5V, the Leisure Battery Discharge alarm goes automatically on,
the symbol ref. 8 starts blinking and you hear two short beeps. Alarms go off when the voltage gets over
12.5V.
MINIMUM VOLTAGE CONTROL (BATTERY PROTECTION)
The electronic battery protection device cuts off the 12V users when leisure battery reaches 10V and
disables: pump, lights, awning light, and stove.
Symbol ref. 1 is the visual alarm signal.
It is possible to reactivate all users for one minute by pressing the on/off button (ref. 5 on control
panel).
The control panel automatically turns off with a voltage lower than 9.5V.
Users are automatically reactivated when voltage is bigger than 13.5V.
This device doesn't control the functions: fridge, step and the auxiliary exit DIR.
TANKS
a) Drink water tank with electronic probe: levels are displayed numerically in % (steps of 10%) and
graphically by the level guage ref. 5
b) Waste water tank with screw probe.
DRINK WATER TANK REFILLING
This function is used during the drink water refilling and shows the water level during refilling.
To activate this function press the "PROG" button ref.1 for more than 2 seconds, until the "water
refilling" screen is displayed.
The control panel beeps in order to warn that tank is getting filled: one short beep at 75-80%,two short
beep at 85-90% and a long beep at 95-100%.
To exit this function press buttons ref. 2 and 3.
DRINK WATER TANK ALARM
Alarm turns on when drink water level is lower than 10% of the tank capacity and automatically turns
off when level exceeds 20%.
Alarm is shown acoustically (when engine is off) and visually with the symbol ref. 7 blinking.
WASTE WATER TANK ALARM
Alarm turns on when the waste water level exceeds the screw sensor level.
Alarm is shown acoustically (when engine is off) and visually with the symbol ref. 9 blinking.
DIGITAL CLOCK
To set clock see "SETTING".
GB
GB
19