Blade Sharpening - Black+Decker MM2000 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6. To tighten firmly, position the piece of
wood as shown in Figure U to keep
the blade from turning. Secure nut
with the wrench.
U

BLADE ShARPENING

Keep blAde ShARp fOR beST mOWeR
peRfORmAnce. A dUll blAde dOeS
nOT cUT gRASS cleAnly.
USe pROpeR eye pROTecTiOn
While RemOVing, ShARpening,
And inSTAlling blAde. enSURe
ThAT mOWeR iS UnplUgged.
Sharpening the blade twice during a
mowing season is usually sufficient
under normal circumstances. Sand
causes the blade to dull quickly. if your
lawn has sandy soil, more frequent
sharpening may be required.
REPLACE BENT OR DAMAGED
BLADE IMMEDIATELy.
WhEN ShARPENING ThE
BLADE:
1. make sure blade remains balanced.
2. Sharpen blade at the original cutting
angle.
3. Sharpen cutting edges on both ends
of blade, removing equal amounts of
material from both ends.
TO ShARPEN BLADE IN A vISE:
(Figure v)
1. be sure the bail handle is released, the
blade has stopped and the mower is
unplugged before removing the blade.
2. Remove blade from mower. See
instructions for removing and installing
blade.
3. Secure blade (33) in a vise (36).
4. Wear proper eye protection and gloves
and be careful not to cut yourself.
5. carefully file the cutting edges of
the blade with a fine tooth file (37)
or sharpening stone, maintaining the
angle of the original cutting edge.
6. check balance of blade and balance
i needed before reattaching. See
instructions for blade balancing.
7. Replace blade on mower and
tighten securely. See instructions for
removing and installing blade.
v
33
BLADE BALANCING (Figure W)
check balance of the blade (33) by
placing center hole in the blade over
a nail or round shank screwdriver
(38), clamped horizontally in a vise
(36). if either end of the blade rotates
downward, file along the sharp edge
of that dropping end. blade is properly
balanced when neither end drops.
W
LUBRICATION
no lubrication is necessary. do not oil
the wheels. They have plastic bearing
surfaces which require no lubrication.
CLEANING
Release bail handle (2) to turn mower
off, let the blade come to a stop and
unplug mower. Use only mild soap
and a damp cloth to clean the mower.
clean out any clippings which may
have accumulated on the underside of
the deck. After several uses, check all
exposed fasteners for tightness.
PREvENTING CORROSION
fertilizers and other garden chemicals
contain agents which greatly accelerate
the corrosion of metals. if you mow in
12
37
36
33
38
36

Publicidad

Tabla de contenido
loading

Tabla de contenido