Worx WG502 Manual De Instrucciones página 9

OPTiON 2
ATTAcHiNg ExTENSiON cORD
1. To prevent disconnection of the tools from
the power supply, secure the extension
cord to extension cord holder found on the
power cord of the tool.
2. An extension cord holder is supplied to
reduce strain on the extension cord. To use
this feature, form a loop at the end of the
extension cord and bring it through the
opening of the cord holder and then pull it
over the hook. (See Fig. M)
Safe Operation Practices for Electric
Blowers and Vacuums
1) Training
a) Read the operating and service instruction
manual carefully. Be thoroughly familiar
with the controls and the proper use of the
equipment.
b) Never allow children to operate the tool.
c) Keep the area of operation clear of all
persons, particularly small children, and
pets.
d) Do not use the tool for any job except that
for which it is intended.
2) Preparation
a) Thoroughly inspect the area where the
equipment is to be used and remove all
stones, sticks, wires, bones, and other
foreign objects.
b) Do not operate the equipment when
barefoot or wearing sandals. Always wear
substantial footwear.
c) Operate the appliance only in daylight or in
good artificial light.
d) Always be sure of your footing. Keep a firm
hold on the handle and walk, never run.
3) Operation
a) Do not put hands or feet near or under
moving parts.
b) If the equipment should start to vibrate
abnormally, stop the motor and check
immediately for the cause. Vibration is
generally a warning of trouble.
c) Stop the motor and unplug whenever you
leave the equipment, before cleaning the
Blower, and before making any repairs or
All-in-one Blower/Vac/Mulcher
inspections.
d) Shut the motor off and wait until the fan
comes to a complete stop before removing
the bag or before unclogging the chute.
e) Do not wash with a hose, avoid getting
water in motor and electrical connections.
4) Maintenance
a) Keep all nuts, bolts, and screws tight to
be sure the equipment is in safe working
condition.
b) check collection bag frequently for
deterioration and wear, and replace
worn collection bags. Only use WORX
replacement collection bag.
ADDITIoNAL sAFETY
INsTrUCTIoNs For YoUr
TooL
1. Do not place inlet or outlet tubes near eyes
or ears when operating.
2. Do not cross gravel paths or place the tool
on gravel while the tool is switched on.
3. Do not place any objects into the openings
near moving parts.
4. Do not operate blower/vac in a gaseous
or explosive atmosphere. Motors in these
tools normally spark, and the sparks might
ignite explosive fumes.
5. Before removing the blow tube, always
switch off the tool, unplug and allow the
tool to come to a complete stop before
removing the tube.
6. Avoid dangerous environment. Do not use
appliances in damp or wet location.
7 . Do not use in rain.
8. KEEP cHILDREN, BYSTANDERS AND
ANIMALS AWAY from the work area a
minimum of 30 feet (10 meters) when
starting or operating the tool. Do not blow
debris in directions of bystanders.
9. Dress properly. Do not wear loose clothing
or jewelry. They can be caught in moving
parts. Use of protective gloves and
substantial footwear is recommended
when working outdoors. Wear protective
hair covering to contain long hair.
10. Use the right tool for the right job. Do not
9 9
EN