Sears Kenmore 116.29429 Manual De Instrucciones página 14

cleaning andservicingthe POWER-MATE
TM
WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit,
Failure to do so could result in elec-
trical shock or personal injury from
cleaner suddenly starting,
1, Remove light
cover by pressing
in and lifting both
sides as shown_
•!iiiii!!ii!ii!i!i !!i
TM
il
Push In
And Turn
2, Push in and turn
bulb counterclock-
wise to remove_
3. Replace the bulb,
Bulb must not be
higher than 15 Watts
Close light cover until
it snaps in place.
NOTE: See PARTS AND FEATURES for
Bulb #
Disconnect cleaner from electrical outlet.
Check and remove hair, string and lint buildo
up frequently in the POWER-MATE
TM
brush
and brush support areas, tf build-up
becomes excessive, disconnect POWER-
MATE
TM
from wand and follow the steps
below_ Instructions can also be found under
the light cover,
TO REMOVE BELT:
--'-I
1. Remove light
cover and light
bulb as shown
under LIGHT
BULB
CHANGING.
2. Unscrew the
POWER-
MATE
TM
cover
screws.
3. Turn
POWER-
MATE
TM
over.
To remove
cover, insert
screwdriver at
cover tabs on
both sides and
twist to
release tabs.
4, Turn POWER-
MATE
TM
right
side uF Press
handle release
pedal and lower
the swivel Tilt
cover forward
from back until
front snaps free,
14