HOW TO START
Personal
Injury
and Product
Damage
Hazard
• DO NOT plug in if switch
is in ON
position.
Personal
injury
or
damage
could
result.
° The cord moves
rapidly
when
rewinding.
Keep children
away
and provide
a clear path when
rewinding
the cord to prevent
personal injury.
° DO NOT use outlets above
counters. Damage to items
in
surrounding
area could occur.
Cord
Rewind
Bar
1o Pull cord out of
canister to desired
length, The cord
wilt not rewind until
the cord rewind
bar is pushed.
NOTE: To reduce the risk of electric shock,
this vacuum cleaner has a polarized
plug,
one blade is wider than the other, This plug
will fit in a polarized
outlet only one way. If
the plug does not fit fully in the outlet,
reverse the plug_ If it still does not fit, con-
tact a qualified electrician
to install the prop-
er outleL Do not change the plug in any
way_
2. Plug the polarized
power cord into a 120
Volt outlet located near the floor°
To rewind: Unplug the cleaner, Hold the
plug while rewinding
to prevent damage or
injury from the moving cord_ Push cord
rewind barn
Handle
Release
Pedal
Pile Height
indica tot
Pile Height
Pedal
3. Lower wand from upright position by
pressing on the handle reiease pedal.
4. Select a pile height setting by pressing
the small pedal on the rear of the POWER-
MATE
TM
. The pile height setting shows on
the indicator, See SUGGESTED
PILE
HEIGHT SETTINGS
Select a switch
position on the
handle°
OFF
FLOOR - turns on the canister
motor onlyo
CARPET.
turns on both the canister and
the POWER-MATE
TM
motors