General Power Tool Safety Warnings - Maktec MT904 Manual De Instrucciones

ENGLISH (Original instructions)
1. Shaft lock
2. Lock button
3. Switch trigger
4. Wheel guard
5. Screw
6. Bearing box
SPECIFICATIONS
Model
Depressed center wheel diameter
Max. wheel thickness
Spindle thread
Rated speed (n)/No load speed (n
Overall length
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding of metal and stone
materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects to
the operation of other equipment. With a mains
impedance equal or less than 0.44 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
4
Explanation of general view
7. Lock nut
8. Depressed center grinding wheel/
Multi-disc
9. Inner flange
10. Lock nut wrench
11. Exhaust vent
) 11,000 min
0
GRINDER SAFETY WARNINGS
ENE077-2
Safety Warnings Common for Grinding Operations:
ENF002-2
1. This power tool is intended to function as a
2. Operations such as sanding, wire brushing,
ENF100-1
3. Do not use accessories which are not specifically
4. The rated speed of the accessory must be at least
GEA010-1
5. The outside diameter and the thickness of your
6. Threaded mounting of accessories must match
12. Inhalation vent
13. Limit mark
14. Brush holder cap
15. Screwdriver
MT904
125 mm
6 mm
M14 or 5/8" (country specific)
-1
361 mm
2.8 kg
/II
grinder. Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed
below may result in electric shock, fire and/or serious
injury.
polishing or cutting-off are not recommended to
be performed with this power tool. Operations for
which the power tool was not designed may create a
hazard and cause personal injury.
designed and recommended by the tool
manufacturer. Just because the accessory can be
attached to your power tool, it does not assure safe
operation.
equal to the maximum speed marked on the power
tool. Accessories running faster than their rated
speed can break and fly apart.
accessory must be within the capacity rating of
your power tool. Incorrectly sized accessories
cannot be adequately guarded or controlled.
the grinder spindle thread. For accessories
mounted by flanges, the arbour hole of the
accessory must fit the locating diameter of the
flange. Accessories that do not match the mounting
hardware of the power tool will run out of balance,
vibrate excessively and may cause loss of control.
MT905
150 mm
-1
10,000 min
361 mm
2.8 kg
GEB110-2