TECshow Mini-Hive 10 Manual De Usuario página 7

Menu Instruction
DMX address setting
• Press MENU when it shows Address, then press
ENTER.
• Change the DMX address by UP or DOWN.
Function selection
• Press MENU until it shows Intro, press ENTER
Press UP or DOWN to choose Reset, Run.
•
When choosing Reset, press ENTER and press UP
•
or DOWN to choose YES or NO. When choosing
YES, press ENTER the equipment reset, restore
factory sett.
• When choosing Run, press ENTER press UP or
DOWN to choose DMX512, Auto1, Auto2, Auto3,
Sound1, Sound2, Slave. When choosing DMX512
the DMX controller sending the signal (3 pin signal
is valid).
• When choosing Auto1, Auto2, Auto3, Sound1 or
Sound2, Auto1, Auto2, Auto3, Sound1, Sound2
choose Auto or Sound mode, it can be used as
the master. When choosing Slave it is Slave receive
the Master signal. Choose the Slave need to quit
to the main menu can be controlled.
DMX Mode selection
• Press MENU until it shows Users mode press
ENTER.
• Choose Channel mode by pressing UP or
DOWN: 25CH, 55CH.
Test Procedure
Press MENU until it shows Test and then press
•
ENTER.
• Press UP or DOWN to choose All Pan & Tilt and
LED. When selecting All it is testing the motor
and LED. When selecting Pan & Tilt to test the
motor choose LED; it is only LED operated.
Adaptive function setting
• Press MENU until it shows Set and then just
press ENTER.
• Press UP, DOWN to choose Disp.setting, Pan
Tilt.
When selecting Disp.setting press ENTER, press
•
UP or DOWN to choose Shut off time, Flip dis-
play, Key lock, or Disp flash. If selecting Shut
off time press ENTER operate UP or DOWN it
can be set LCD backlight close from 2-60 mins.
When selecting Key lock press ENTER and op-
•
erate UP or DOWN. Enter Option ON/OFF and
select option ON. When the backlight shuts off,
the button key is locked, it means the operation
is invalid at this time. It must be entered Up,
Down, Down, then press ENTER to confirm the
unlock. When selecting Disp flash, press EN-
TER, operate UP or DOWN, it can be choosed
ON/OFF, choose ON, the screen's backlight
begin to blink when the equipment received
the DMX signal; that means it has received
the DMX signal. The screen's backlight closed
when there is no signal. When selecting Pan or
P. 7
| Tecshow Mini-Hive 10
English version