Charging The Batteries Using Direct Charger; Charging The Batteries Using Desktop Charger (Twintop 400 Only) - Swissvoice TwinTop 400 Manual De Usuario

Installation

Charging the batteries using direct charger

1. Lift up the Mic/Ear/Charger cover, insert the round
connector at the side of the unit.
2. Plug in the mains adaptor into a 240 V/50 Hz
main socket.
Note It takes about 10 hours to fully recharge the
batteries if they are completely run down.
New batteries take up to 14 hours to fully
charge.

Charging the batteries using desktop charger (TwinTop 400 only)

1. Insert the small plug on the end of the mains adaptor into the power-in connection
jack at the back of the desktop charger.
2. Plug the mains adaptor into a 240 V/50 Hz main socket.
3. Place the TwinTop 400 unit in the charge cradle in an upright position and facing
outward. The charge LED indicator will light up.
Nota – The TwinTop 400/400-L must be charged using the mains adaptor
provided. Using any other adaptor will result in non-compliance with
EN60065 and will invalidate any approvals and warranty.
– It takes about 10 hours to fully recharge the batteries if they are com-
pletely run down. New batteries take up to 14 hours to fully charge.
– Always turn off the PMR unit when charging. This will shorten the
charging .
– During PMR direct charging mode, the functions transmit and receive
are disabled.
Main socket
20