Description
KETTLE:
A : Body
B : Gooseneck spout
C : Handle
D : Lid
CONTROL PANEL
E : LED display
shows the water temperature in the
kettle
F : START/STOP button
Press to start or stop the boiling cycle
• Remove all various packaging, stickers or accessories from both the inside and outside
of the kettle (do not forget to remove the transparent protective film from the screen).
• Adjust the length of the cord by winding it under the base. Wedge the cord into the
notch (fig. 1).
• Before first use, rinse the kettle. Boil water at maximum capacity 2 or 3 times. Throw
away the water.
Use
1) Place the base on a flat, stable, heat-resistant surface away from water splashes
and any sources of heat.
• Kettle is only to be used with the base provided.
2) Fill the kettle with the desired amount of water. (fig 3)
• Never fill the kettle when it is on its base.
• Do not fill it above the maximum level (40.57oz / 1.2L), or below the minimum level
(16.91oz / 0.5L). If the kettle is too full, boiling water may spill out (fig 4).
• Do not use without water.
• Check that the lid is closed properly before use (fig 5).
3) Position the kettle on its base. Plug it into the outlet.
4) To start the kettle
• Place the kettle on the base, the KEEP WARM INDICATOR will briefly illuminate in red
and the LED DISPLAY will show the current temperature. Press either the + or - buttons
and the last use temperature / default temperature will be displayed (fig 7).
TO BOIL THE WATER
2 options:
• You can start boiling water at default temperature (93°C /200° F) by pressing the
START/STOP Button.
Before using for the first time
G : + button
Press to increase the temperature
H : – button
Press to decrease the temperature
I : Timer
Press to start or stop the timer
J : Keep warm indicator
When lit, the kettle is maintaining
the water temperature for up to
30 minutes
EN
7