HumanTechnik lisa time S Instrucciones De Servicio página 8

Interrupting/switching off the alarm
signal:
For 9 minutes (snooze):
By pressing the snooze button
»Snooze function«
For 24 hours:
By pressing the »ALARM STOP 24 h«
For a longer period (weekend, holi-
day):
Reset the switch on the back to 0
Special features of lisa time S
• When using the alarm clock for the
first time it is possible that the inter-
nal battery needs to be recharged.
This means that the alarm clock will
only be fully functional after about
six hours.
• lisa time S is also a receiver for the
lisa signalling system. From the 4
signal lights you can recognise
which alarm signals (door, tele-
phone, baby, alarm or beeper) are
being issued. As with all lisa devi-
ces lisa time S has a switch to change
channels (also see lisa operating
instructions).
• The brightness of the display can
be set by a potentiometer.
• The built-in battery can bridge a
power failure of at least one hour.
During this time the time and alarm
setting remain saved.
8 English
• If a light is connected it can be
switched on when the switch is in
the "light on" position. Please note
that when the switch is in this posi-
tion the switch output does not have
an alarm function.
Maintenance and care
The lisa time S does not require any
maintenance. If the unit does become
dirty, simply wipe it clean with a soft,
damp cloth. Never use spirits, thin-
ners or other organic solvents. Do not
set up the unit where it will be expo-
sed to full sunlight for long periods.
In addition it must be protected
against excessive heat, moisture and
severe mechanical shock.
Note: This product is not protected
against splash water. Do not place
any containers filled with water, such
as flower vases, or anything with an
open flame, such as a lit candle, on or
near the product.