Loewe One Serie Instrucciones De Instalación página 24


One 40-55
Installation instructions
Installing the TV set
Connecting the TV set
Installing the TV set
Choose a place for installing your TV set where no bright light or
sunlight shines directly onto the screen. This could cause reflections
which impair the picture.
3 times the screen diagonal can be taken as a guide value for the
viewing distance (e.g., for a 55-inch set approx. 4,2 m for SD signal).
The viewing distance can be reduced with an HD/UHD signal.
Connecting the TV set
Connecting to the mains supply
Connect the TV set to a 220-240V mains socket:
One 55: Connect the plug of the power cord fixed to the TV set with
a mains socket.
One 40: First plug the smaller plug (small connector) of the power cord
into the AC inlet (AC IN) on the TV set, and then the larger connector
(Euro plug) into a mains socket.
One 40
Connecting antennas
Plug the cable of antenna, cable TV system or room antenna into the
ANT TV socket.
If you want to use analogue cables / DVB-C connection and a DVB-T
antenna together, use an external antenna switch (available from
your dealer).
Satellite antenna DVB-S:
Depending on the used satellite system, connect a connecting cable
from the multi-switch or directly from the LNC to the ANT-SAT and
ANT-SAT2 (1 sockets of the TV set respectively.
When connecting the TV set to a single cable community antenna,
connect the ANT-SAT and ANT-SAT2
appropriate SAT antenna socket.
When connecting the TV set to a DiSEqC single cable community
antenna (in accordance with EN 50494), connect the ANT-SAT
socket directly to the appropriate SAT antenna socket.
Cable DVB-T
analogue /
DVB-C
R TV
(1 ANT SAT 2 exists only on device type One 55.
10
36592001_QG_One_40-55_2_GB_00_Buch.indb 10 36592001_QG_One_40-55_2_GB_00_Buch.indb 10
Connecting the TV set to the Home network
You may link your TV set to the home network by a wired connection
(Ethernet, Powerline adapters separately available) or by a wireless
radio connection (WLAN). For wireless connections, the TV set has
an internal WLAN antenna.
In order to play back data from your home network your Loewe TV
supports the UPnP AV standard.
You call the network wizard to configure the network adaptor (System
settings → Multimedia/Network → Network settings → Net-
working).
Under no circumstances may the TV set be wired and at the same
time connected by a wireless connection to the same network, e.g.
router. This may cause severe operational faults!
Example for a wired connection
Connect the LAN socket of your TV set to the LAN switch/router of
your home network with a network cable (available from your dealer).
TV set
One 55
Example for a wireless connection
You can connect the TV set to your home network by a wireless radio
connection via the WLAN antenna inside the set.
Shadow effects of various materials, such as reinforced concrete,
metal surfaces, etc., attenuate the WIFI signal sometimes
significantly or completely.
TV set
(1
sockets directly to the
DVB-S
Help for configuration problems
Loewe cannot provide any support for PC hardware and software or
network components owing to the diverse configuration options with
home networks.
Please contact the administrator of your home network and/or specialist
dealer for support when setting up and for maintenance of network
connections, storage media, media server software and network devices
such as routers.
LAN switch/router
PC
DSL
WLAN router
PC
DSL
06.04.2016 16:33:17 06.04.2016 16:33:17
