Troubleshooting - Hercules HHEK 22-40 Manual De Instrucciones

Anleitung_HHEK 22-40_SPK7:_
GB

12. Troubleshooting

Caution!
Before troubleshooting, switch off the tool and disconnect the mains plug.
The table below contains a list of fault symptoms and explains what you can do to remedy the problem if your
tool fails to work properly. If the problem still persists after working through the list then please contact your
nearest service workshop.
Cause Fault
Chainsaw does not work Quick stop brake has been triggered
at all
No power supply
Defective mains outlet
Power extension cable damaged
Defective fuse
Chainsaw operates Power cable damaged
intermittently
Loose connection (external)
Loose connection (internal)
ON/OFF switch defective
Saw chain dry No oil in the tank
Oil tank cap breather blocked
Oil outlet blocked
Chain brake does not Problem with the switch mechanism in
work the front hand guard
Chain/guide rail hot No oil in the tank
Oil tank cap breather blocked
Oil outlet blocked
Blunt chain
Chainsaw juddering, Chain tension too loose
vibrating or not sawing
Blunt chain
properly
Worn chain
Saw teeth pointing in the wrong direction Reinstall the saw chain with the teeth
24
27.06.2008 12:22 Uhr Seite 24
Remedy
Pull the hand protection back to the
normal position.
Check the power supply.
Try an alternative source of electrical
power, replace if necessary.
Check the cable and replace as
required.
Replace the fuse.
Consult a specialist workshop.
Consult a specialist workshop.
Consult a specialist workshop.
Consult a specialist workshop.
Fill up with oil.
Clean the oil tank cap.
Clear the oil outlet.
Consult a specialist workshop.
Fill up with oil.
Clean the oil tank cap.
Clear the oil outlet
Re-sharpen or replace the chain.
Adjust the chain tension.
Re-sharpen or replace the chain.
Replace the chain.
facing in the correct direction.