Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting
• Save all instructions
PROBLEM
POSSIBLE CAUSE(S)
Engine will not
1. Ignition Switch in the "OFF"
start.
position.
2. Engine flooded.
3. Fuel Tank empty.
4. Spark Plug not firing.
5. Fuel not reaching carburetor.
6. Carburetor requires adjustment.
Engine will not
1. Choke on.
accelerate, lacks
2. Air filter dirty.
power or stalls.
3. Spark Plug fouled.
4. Carburetor requires adjustment.
5. Carbon build-up on Muffler outlet
screen.
6. Compression low.
Engine smokes
1. Fuel mixture incorrect.
excessively.
2. Air filter dirty.
3. Carburetor requires adjustment.
Engine runs hot.
1. Fuel mixture incorrect.
2. Spark Plug incorrect.
3. Carburetor requires adjustment.
4. Carbon build-up on muffler outlet
screen.
Engine will not idle
1. Carburetor requires adjustment.
properly.
2. Crankshaft seals worn.
3. Compression low.
Auger bit turns
1. Idle speed too high. Carburetor
while engine is idle
requires adjustment.
Auger bit jumps or
1. Worn Earth Blade or Fishtail
drills slowly.
Point.

Technical Service

You may have further questions about assembling, operating, or maintaining this Earth Auger. If so, you can contact our
Technical Service Department at 1-800-737-2112 (English only).
You may also write to:
METL Corporate Office - CORRESPONDENCE ONLY
ATTN: Technical Service – METL
6700 Wildlife Way
Long Grove, IL 60047
When contacting the Technical Service Department, have
ready:
• Your Name
• Your Address
• Your Phone Number
Questions? Call Toll Free at 1-800-737-2112
SOLUTION(S)
1. Move Ignition Switch to the ON position.
2. See Starting A Flooded Engine in OPERATION section.
3. Fill tank with correct fuel mixture.
4. Replace Spark Plug.
5. Check for kinked or split fuel line; repair or replace.
6. Call toll free phone number below for technical assistance.
1. Move Choke Lever to "Run/Warm Start" position to turn off choke.
2. Clean air filter.
3. Clean or replace Spark Plug
4. Call toll free phone number below for technical assistance.
5. Call toll free phone number below for technical assistance.
6. Call toll free phone number below for technical assistance.
1. Empty Fuel Tank and refill with correct fuel mixture.
2. Clean or replace air filter.
3. Call toll free phone number below for technical assistance.
1. See Mixing Gasoline / 2-Cycle Oil in OPERATION section.
2. Replace with correct Spark Plug.
3. Call toll free phone number below for technical assistance.
4. Call toll free phone number below for technical assistance.
1. Call toll free phone number below for technical assistance.
2. Call toll free phone number below for technical assistance.
3. Call toll free phone number below for technical assistance.
1. Call toll free phone number below for technical assistance.
1. Replace it with corrected part from manufacturer.
If you need assistance or have any questions,
CALL TOLL FREE: 1-800–737-2112
• Model Number of Product
• Date of Purchase (include copy of receipt for written requests)
EN - 11
Copyright © 2015 MAT Engine Technologies, LLC

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sea43.1Sea438Sea43

Tabla de contenido