Troubleshooting Table - Weed Eater WEB 200 Manual De Instrucciones

,&
_IIWARNING: Perform the following
steps after each use:
• Stop unit and disconnect from the pow-
er source.
• Allow motor to cool before storing or
transporting.
• Store unit with all guards in place. Posi-
tion unit so that any sharp object cannot
accidentally cause injury.
• Store unit unplugged, well out of the
reach of children.
SEASONAL STORAGE
Prepare unit for storage at the end of
the season or if it will not be used for
30 days or more.
TROUBLESHOOTING TABLE
If your blower is to be stored for a period
of time:
• Stop unit and disconnect from the pow-
er source.
• Clean the entire unit before lengthy stor-
age.
• Inspect the blower and blower tube.
Close and make sure the cover is
latched.
• Clean air vents and air inlet of debris.
• Store your unit and extension cord in a
well ventilated area and covered, if pos-
sible, to prevent dust and dirt accumula-
tion. Do not cover with plastic. Plastic
cannot breathe and may cause con-
densation and eventual rust or corro-
sion.
• Check entire unit for loose screws. Re-
place any damaged, worn, or broken
parts.
_i, WARNING: Always stop unit and disconnect from the power source before
performing all of the recommended remedies below except remedies that re-
quire unit to be operating.
SYMPTOM CAUSE REMEDY
Unit fails to 1. Switch in the OFF position. 1. Slide switch to ON position.
operate. 2. Extension cord discon- 2. Reconnect extension cord.
neoted.
3. Circuit breaker tripped, or 3. Reset circuit breaker or
fuse blown, fuse.
4. Mechanical failure 4. Contact your authorized
service dealer.
Unit 1. Mechanical failure 1. Contact your authorized
vibrates service dealer.
abnormally.
Impeller will 1. Debris in air intake area. 1. Clean unit. Remove any
not turn 2. Mechanical failure, debris.
freely. 2. Contact your authorized
service dealer.