Lcd Setting - Infosec HV Serie Manual De Usuario

3-7. LCD Setting

There are three parameters to set up the UPS. Refer to diagram 13.
Parameter 1
Parameter 2
Diagram 13 :
List of 20 programs available for parameter 1:
Code Description
01 Output voltage
02 Output frequency
03 Voltage range for bypass
04 Frequency range for bypass
05 ECO mode enable/disable
06 Voltage range for ECO mode
07 Frequency range for ECO mode
08 Bypass mode setting
09 Maximum battery discharge time setting
10 Reserved
11 Hot standby function Setting
12 Neutral loss detection
13 Battery voltage calibration
14 Charger voltage adjustment
15 Inverter A voltage adjustment
16 Inverter B voltage adjustment
17 Inverter C voltage adjustment
18 Output A voltage calibration
19 Output B voltage calibration
20 Output C voltage calibration
*Y (YES) means that this program can be set in this mode.
NOTE: All parameter settings will be saved only when UPS shuts down normally with internal or external
battery connection. (Normal UPS shutdown means turning off input breaker in bypass/no output mode).
INFOSEC UPS SYSTEM – 15, rue du Moulin – 44880 Sautron – France – www.infosec-ups.com
87
hotline : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 07 19 AA 59 205 03
Parameter 3
LCD Settings
Parameter 1 is for program alternatives. There
are 20 programs to set up. Refer to the table
below.
Parameter 2 and parameter 3 are the setting
options or values for each program.
NOTE: Select "Up" or "Down" buttons to
change the programs or parameters.
Bypass AC Eco
Y*
Y
Y
Y
Y
Y
Y
Y Y
Y Y Y
Reserved for future options
Y
Y Y Y
Y Y Y
Y Y Y
Y
Y
Y
Y
Y
Y
Battery
CVCF Battery
Test
Y Y Y
Y Y Y
Y Y Y
Y Y Y
Y Y
Y Y
Y Y
Y Y
Y Y
Y Y