Connecting The Gps Receiver To A Terminal - Amazone AG-STAR Instrucciones De Instalación Y Operación

3.2
Procedure
V6.20160115

Connecting the GPS receiver to a terminal

NOTICE
Terminal connector supplying power
Potential damage to the terminal from a short-circuit.
◦ Switch the terminal off before plugging in or removing the connector.
This is how you connect the GPS receiver to a terminal:
1. Switch off the terminal.
2. Route the cable of the GPS receiver into the vehicle cab.
3. Find the appropriate RS232 connection on the terminal. Refer to the operating
instructions for the terminal to find out which connection this is.
⇨ You have now connected the GPS receiver to the terminal.
Mounting and configuration
Connecting the GPS receiver to a terminal
3
23