Pyramid 2500 Pro Manual Del Usuario página 12

AUTO ALIGNING TIME CLOCK INSTRUCTIONS
Model 2500/2650
Functions 09 and 10 are only necessary if adjustment is required to properly align the
print position within the "punch square" on the time card. To perform a "print test" to
determine if the time clock is printing properly, switch the SETTING button to the left.
Run a test card through the time clock. If the alignment is acceptable, skip sections 09
& 10 and proceed to stop 11.
09-SET PRINT POSITION UP/DOWN OPTIONAL
In SETTING mode, Press "ENTER" to begin "09" setting mode.
1
Press "+" or "-" to adjust the desired vertical printing position.
2
Increasing the number (06-09) will move the print up on the card.
Decreasing the number (00-04) will move the print down on the card.
Press "ENTER" to confirm setting.
3
4 The setting mode advances to "10".
Continue to next steps or slide the SETTING switch to the left
5
to exit setting mode.
10-SET PRINT POSITION LEFT/RIGHT OPTIONAL
1
In SETTING mode, Press "ENTER" to begin "10" setting mode.
2
Press "+" or "-" to select the desired horizontal printing
position. Increasing the number (06-09) will move the print to
the right on the card. Decreasing the number (00-04) will move
the print left on the card.
3
Press "ENTER" to confirm setting.
4
The setting mode advances to "11".
Continue to next steps or slide the SETTING switch to the left
5
to exit setting mode.
11-SET ON/OFF FUNCTION FOR AUTO-DETECT TIME CARD SIDE
Because this time clock uses a double sided time card, the auto-detect feature assures
the time card is inserted on the correct side corresponding to the date printed on the
time card (days 1-31) If the time card is inserted backwards (on the wrong side), the
time clock will eject the card until the correct side is inserted. Auto-detection "01" is
recommended.
In SETTING mode, Press "ENTER" to begin "11" setting mode.
1
Press "+ or "-" to select "01" or "02"
2
01-auto-detect time card
02-turns off auto-detect time card
Press "ENTER" to confirm setting.
3
4
Slide the SETTING switch to the left to exit setting mode.
10 PROGRAMMING 888.479.7264