Preparation Of Chassis - Heat Controller Comfort-Aire REG-183A Manual Del Usuario

installation
SCREWDRIVER(+,-), RULER, KNIFE, HAMMER, PENCIL, LEVEL
PREPARATION OF CHASSIS
1_Remove the screws which fasten the cabinet at
both sides and at the back.
2. Slide the unit out from the cabinet by gripping
the base pan handle and pulling forward while
bracing the cabinet.
3 Cut the window sash seal to the proper length
Peel off the backing and attach the Foam-PE to
the underside of the window sash.
Shippingscrews
Fig. 1
4. Remove the backing from Foam-P'E with 3 holes
and attach it to the bottom of the Top retainer
bar.
5 Attach the Top retainer bar on the top of the
cabinet with 3 screws (_jpe A).
Fig, 2
6. Insert the Frame guides into the bottom of the
cabinet.
7. Insert the Frame Curtain into the Top retainer bar
and Frame guides.
8. Fasten the curtains to the unit with 10 screws
(Type A) at both sides.
FoamoPE
Top re_ir, er bar
Top retainerbar
"Frame guide
Sicrew_ype A}
Fig. 4
Owner_ Manual 13