Pairing With A Bluetooth Phone - IOGear GBE211 Manual Del Usuario

Pairing to Bluetooth Phone
Pairing Procedure
Pairing is a Bluetooth function that enables Bluetooth devices to remain permanently
linked to each other. By pairing devices, you only need to authenticate and authorize
communication between your devices once. During the pairing procedure, a PIN code is
required for secure authentication. Thereafter, communication between your two Bluetooth
devices is done automatically without requiring authentication or confirmation.
For the procedure below, you will need to know how to use your cell phone's Bluetooth
feature for discovering, connecting, and pairing to other Bluetooth devices. If you're not
sure how to do this, please consult your cell phone user manual.
To pair the IOGEAR Bluetooth headset with your Bluetooth phone, follow the
procedure below:
1. Turn headset ON (see page 8 under Introduction)
2. Press and hold the Volume-Up (+) button for more than four (4) seconds; the red LED
will turn ON and the blue LED will start rapidly flashing; the headset is now in pairing
mode.
NOTE: If only the blue LED is on, the headset is in stand-by mode; repeat the step again and make sure
12