Greenlee Textron GVIS 300 Manual De Instrucciones página 17

Magnify and Center
Click the Magnify and Center button to magnify the image displayed approximately 2.5 times and to center the
fiber end face. See Figure 8.
To return to the normal view, click the Full Field of View button.
Voice On/Off
Voice commands can be used in situations when both hands are busy. Voice commands can be turned on and
off by clicking the Voice Commands button. When on, command feedback is given as illustrated in Figure 9.
When green, the command was understood. When yellow, a command was understood but may have been
misinterpreted. Red indicates the command was not understood.
Below are a few voice commands that can be used rather than clicking on a button.
Button
Capture Image
Hold/Read*
Save/Measure*
Magnify & Center*
Analyze
Voice Commands On
* For these commands you can use the same command to toggle between button states. For example, when
you say "Center Image", GVIS magnifies and centers the image. Rather than saying "Full View", you can say
"Center Image" again to return back to full view.
Greenlee / A Textron Company
GVIS 300 • GVIS 400 • GPAD 250
Figure 8. Magnify and Center Screen
Voice Command
"Capture Image" or "Cheese"
"Hold" or "Read"
"Save" or "Measure"
"Center Image" or "Full View"
"Analyze"
"Disable Voice"
17
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070