Filter Maintenance; Paper Bag Filter; Trouble Shooting - Eureka ZUUM Z Serie Manual Del Propietário

the contents. Return the receptacle by attaching the bucket to the power
unit. To avoid suction loss make sure the receptacle is securely attached.
Refer to page 27 - Image 11

FILTER MAINTENANCE

The internal Triumph HEPA filter is permanent and self cleaning.
However, if you have questions about your permanent self-cleaning
fi lter, please contact your local authorized dealer/distributor.
PAPER BAG FILTERS
The volume of the Arm & Hammer paper bag is 22 liters. A full dust bag
reduces the systems performance. Depending on how often you use
your central vacuum system, the dust bag may need to be changed
2-3 times per year – and can be obtained at your local dealer/distributor.
Instructions for changing the dust bag:
1. Remove the power unit dirt receptacle.
2. Loosen the dust bag from the intake tube, remove and dispose.
3. Place and press the new dust bag fi rmly into the tube.
Turn the dust bag's opening to make it fasten fi rmly on the tube.
4. Put the dirt receptacle back on the central power unit.
IF YOU EXPERIENCE TROUBLE WITH YOUR
CENTRAL VACUUM SYSTEM, FOLLOW THE
SUGGESTIONS BELOW BEFORE CALLING
FOR SERVICE.
PARTIAL/TOTAL LOSS OF SUCTION POWER
• Be sure dirt receptacle is on properly.
• Empty dirt receptacle.
• Remove debris from fi lter.
• Be sure each inlet valve is properly closed.
- OPTIONAL
Instructions to install utility inlet – optional
Low voltage wire to cleaner control box
Power unit
PVC pipe Insert (length optional)
CLEAR BLOCKAGE IN PIPES
Blockage in the hose
Plug hose into any inlet valve. If there is no suction through the hose after
connecting at a couple of inlets, the blockage is in the hose. To clear the
hose obstruction, insert a blunt instrument into the hose (garden hose,
wood dowel). You can also attempt to reverse the suction through the
hose to dislodge the blockage.
Refer to page 27 - Image 12 and 13
If there is one inlet valve without normal suction and you have checked
for hose blockage, then the blockage is in the pipe system between the
blocked inlet valve and the power unit (see instructions below).
Insert the hose into the inlet valve where there is no suction; hold your
hand over the hose end. Release hand quickly. Repeat several times.
If blockage does not clear, contact your nearest dealer/distributor.
POWER UNIT WILL NOT START
• Check for blown fuse or circuit breaker in main house electric supply box.
• Unplug and check all wall inlet and low voltage connections for loose wires.
• If unit still will not start, contact your nearest authorized service
station/dealer.
POWER UNIT WILL NOT STOP
• Check inside each inlet valve for obstruction of low-voltage contacts.
If no visual obstruction can be detected, disconnect the cleaner from
the power receptacle and contact your nearest service station/dealer.
CENTRAL POWER UNIT SHUTS OFF BY ITSELF
• Remove and then re-insert hose into inlet or toggle switch off-on
located on hose handle. See "Overload Protection".
Sweep 90 tee
Inlet valve (low voltage)
PVC pipe to system
7