Maintenance - Greenlee HID6506 Operación Manual

Maintenance

Do not change accessories, inspect or clean tool or
accessories when it is connected to a power source.
Accidental start-up can result in serious injury.
Failure to observe this warning could result in severe
injury or death.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from flying
debris or hydraulic oil.
Greenlee / A Textron Company
Hydraulic Rotary Impact Drill
Use this maintenance schedule to maximize the tool's
service life.
Notes: Keep all decals clean and legible. Replace
decals when necessary. Refer to the Service manual for
decal part numbers.
When disposing of any components (hydraulic hoses,
hydraulic fluid, worn parts, etc.), do so in accordance
with federal, state, and local laws or ordinances.
Daily
1. Wipe all tool surfaces clean.
2. Inspect the hydraulic hoses and fittings for signs of
leaks, cracks, wear or damage. Replace if necessary.
3. Install dust caps over the hydraulic ports when the
tool is disconnected.
Monthly
Perform a thorough inspection of the hydraulic hoses
and fittings as described in publication 99930323,
SAE J1273 (Hose and Hose Assemblies).
Annually
If required by your organization's regulations, have the
tool inspected by an authorized Greenlee Utility service
center.
12
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070