Troubleshooting - Fenton KA Serie Manual De Instrucciones

OPERATION:
Connect the passive speaker with the supplied connection cable to the speaker output connector (21).
WARNING: only connected the original slave speaker on the speaker output terminal!
If required connect an external signal source like a CD-player to LINE IN (20).
Connect the device with an electric outlet (230VAC / 50Hz).
LINE INPUT (DVD, CD-player etc.):
1. Connect the source (DVD-player, CD-player etc.) to the line input on the rear panel (20)
2. Push the input selector to Audio position
3. Volume can be controlled with master volume control
USB/SD player:
1. Push the input selector to the USB position.
2. Insert USB-stick or SD-card with MP3 files in the MP3-player.
3. MP3 files will be played after a few seconds.
4. Volume can be controlled with master volume control.
5. Previous track can be selected with PREV button on MP3-player.
6. Next track can be selected with NEXT button on MP3-player.
7. Pressing the PAUSE button on the MP3-player will pause the song and again pressed will
continue playing.
MICROPHONE:
1. Insert the microphone to the MIC1, MIC2 or MIC3.
2. Adjust the MIC volume.
GUITAR (when available):
1. Insert the guitar to the guitar input jack.
2. Adjust the GUITAR volume.
BT
1. Use the input button (7/5) and select BT mode.
2. Make connection between your BT-device and speaker.
3. A confirmation tone is audible, BT connection is paired.
TROUBLE SHOOTING:
Failure
NO POWER
NO SOUND
ONE SPEAKER WITHOUT SOUND
MICROPHONE NO SOUND
MICROPHONE HOWL
Possible cause
The power line is cut off or not connected
No power on the electric outlet
Wrong input, check input selector (3)
The connect line was broken
The volume knob at lowest
Connection between master & slave unit wrong
Signal line was broke
The microphone not complete connected
Adjust the microphone volume
Change microphone
The microphone is too close to the speaker
Master volume adjust too big
6