Blinking Error Lamp (Red); Specifications - Nikon MV-1 Manual De Instrucciones

Blinking Error Lamp (red)/Specifications

• Blinking Error Lamp (red)

• Repeat operation from step 1 on page 10 after the following remedies.
Blinks slow (once a second): Communication error with camera
Cause
Camera power is off
Shutter is released during communication
with camera
Plug is loose
Blinks fast (4 times a second): Memory card error
Cause
Writing error
Card is not properly inserted into the slot
Card's available memory is insufficient
Card is not formatted correctly
With F100, a film in use is loaded when
setting/changing recording data
• The memory card and the plug may be inserted or removed freely while the error
lamp is on.

• Specifications

Power
Dimensions (WxHxD)
Cable length
Weight
Operating conditions
Specifications and design are subject to change without notice.
• CompactFlash™ is a trademark of SanDisk Corporation.
• Microsoft®, Microsoft® Excel and Windows® are registered trademarks or
trademarks of Microsoft Corporation in the United States and/or other countries.
• Microdrive is a trademark of Hitachi Global Storage Technologies in the United
States and/or other countries.
• Products and brand names are trademarks or registered trademarks of their
respective companies.
Supplied by camera
Approx. 78 x 25 x 109mm or 3.1 x 1.0 x 4.3 in.
Approx. 400mm or 15.7 in.
Approx. 100g or 3.5 oz. (main unit only, excluding
memory card)
Temperature: 0-40°C or 32-104°F, humidity: under 85%
Remedy
Turn camera power on
Do not release shutter during
communication
Attach plug properly
Remedy
Insert new card
Insert card properly
Insert new (empty) card
Insert correctly formatted card
Remove the film in use
Page
10
7
8
Page
8
8
9
13
21
25