Pentair Water KREEPY KRAULY Legend LL505G Manual De Instalación página 11

E. Cutting the Feed Hose
3. Lay the telepole next to the soft
hose. If the clear soft hose is
longer than the mark on the
telepole, cut the excess from the
end attached to the white (hard)
hose. Do not cut off the float.
Leave the first float in position
next to the Back-Up Valve. Place
the second float midway between
the first float and the Hose Swivel.
4. Attach feed hose to the wall fitting
and attach wall fitting to the pool wall. Hold the end of soft hose and walk the perimeter of the pool
keeping the hose straight (do not stretch hose) to find the farthest point of the pool from the wall
fitting.
5. Measure the excess length between the farthest point of the pool from Wall Fitting and the end of
30 in. (75 cm) soft hose.
6. Half of this measured length is to be cut equally from 10 ft. (3 m.) white (hard) hoses next to the
Marked Swivel. ( Example: Half of 6 ft. [180 cm] = 3 ft. [90 cm] each). If you are cutting more than
2 ft. (60 cm) off the hoses, remove the floats next to the Marked Swivel from both hoses. See
Diagrams on Page
7. Re-assemble the hoses and the swivel using
mender nuts. Put mender nut on swivels first,
then push hose over swivel, rotate mender
nut over hose clockwise until tight.
Note: Keep as many floats as possible on
white feed hoses spaced evenly apart to hold
hose up on top of water.
- (cont.)
White (Hard) Hoses
10.
Telepole / Soft Hose
Swivel
Cut and Remove the
Excess Hose Length
MENDER
FEED
NUT
HOSE
STEP 1
PUSH HOSE OVER BARB
STEP 2
PUSH MENDER NUT TOWARD HOSE AND ROTATE
CLOCKWISE BY HAND UNTIL TIGHT
STEP 3
Water Level
Cut Soft Hose Equal to the
Deepest Pool Water Level
BARB ON SWIVEL
OR LEGEND
SMALL END
OF MENDER
NUT AWAY
FROM HOSE
[English]
LEGEND ® INSTALLATION MANUAL
11