EN
4. Setting the unit
4.1Rear Panel
1 . DMX input: For DMX512 link, use 3/5-pin XLR plug cable to input DMX signal.
2. Display: To show the various menus and the selected functio
3.Menu
4.Up
5.Down
6.Enter
7. Mains input:Connect to supply mains power.
8. DMX output:For DMX512 link, use 3/5-pin XLR plug cable to link the next unit.
4.2 Main Function
To select any functions, press MENU button until the required one is shown on the display.
Select the function by ENTER button and the display will blink. Use DOWN and UP button to
change the mode. Once the required mode has been selected, press ENTER button to
setup . Back to the functions without any change press MENU button. The main functions
are shown below:
BAR 12/4 HOME
To select the program functions
To go forward in the selected functions
To go backword in the selected functions
To confirm the selected funtions
A1:
Effect 1 All bright
A2:
Effect 2 Jump change
A3:
Effect 3 Gradual change
A4:
Sound-activated
A5:
Strobe
Color:
Color adjustment
Speed: Speed adjustment
DMX:
DMX channels select
IP:
Running effect
User Manual/Manual de uso
P 3