Connection Schematic; Connecting An External Audio Device To The Car Radio; Disassembling The Device - Silvercrest KH 2375 Instrucciones De Uso

Attention!
For installation please use the car radio's ISO
connections. The vehicle specific ISO adapter
that you may possibly require can be obtained
from a specialist establishment, from a local
dealer or from the store's technical department.
When using other connection types the warranty
becomes void!
Observe the cable positioning when pushing
the radio in; it could become damaged.
Antenna power connection
The connection for the antenna power is available
for a relay controlled antenna. The relay then
automatically extends the antenna when the radio
is switched on. When switched off the antenna
retracts.
This connection can also be used to control an
external amplifier. For exact connection informa-
tion please consult the amplifier's operating in-
structions.
Never attach the antenna power connection with
the antenna's motor power cable; this can cause
damage to the radio!
Backup connection
Make sure that for the station memory the per-
manent positive is applied to the connection 6
in the ISO block A. Otherwise you will not be
able to save any radio stations!
• After all connections have been made activate the
RESET
button with a ball point pen or other pointed
object.
• Attach the face plate as described under
"Putting the face plate in".

Connection schematic

Antenna
External amplifier
Connecting an external audio
device to the car radio
• Connect the audio output of an external audio
device (i.e. an MP3 player) via a 3.5 mm stereo
jackplug to the socket
the device.
• Select playback of the audio input by pressing,
several times, the
shown in the display.

Disassembling the device

• To disassemble the device first remove the bezel
frame and then feed the right and left keys into
the respective slots on the sides of the device.
The tabs are now bent back and you can pull the
device out.
- 56 -
1 2 3 4
5 6 7 8
1 2 3 4
5 6 7 8
Microphone unit
AUX IN
on the front panel of
MD/LD
button until AUX is
ISO B
ISO A