Self-Clean Mode - Danby Designer Ice'n Easy DIM1524W Manual Del Usuario

1 Add water & vinegar (1:1)
2 With the power off,
simultaneously depress
the increase & decrease
arrows twice.
3 Drain after program is
cornplete.
4 Add fresh water to fill line.
5 Repeat Step 2
6 Drain after program is
complete.
The self-clean mode should be
put into operation before you
use your ice maker for the first
time and/or if there has been a
long period without use
Stage I
* Add equal parts of water and
vinegar (1: t) to the ice maker's
reservoir,
o With the power off, press the
increase and decrease arrows
simultaneously two times to
activate the self-clean mode
Please note, the self clean
mode with automatically initiate
approximately 10 seconds after
the last button depression°
• During the self clean mode,
the upper ice bucket is filled
and dumped multiple times and
the pump will remain in contin-
uous operation as it feeds
water to the bucket and evapo-
rator coils,, This cycle contin-
ues for approximately five-and-
a-half minutes,
Upon completion, the unit auto-
matically powers down and is
now ready for stage 2.
Stage 2
• Drain the cleaning solution
from the internal reservoir by
removing the rear drain cap
and plug (see pg 9),,
• Add fresh water to the 'Fill
line' in the internal reservoir,
o With the power off, press the
increase and decrease arrows
simultaneously two times to
activate the self clean mode-
which will now act as a rinse
Upon completion of this final
stage of the self clean process,
the unit automatically powers
down once again_ Proceed to
drain the water from the inter-
nal reservoir and leave the lid
on the ice maker open to allow
it to air dry
8