Publicidad
①
12
②
③
English
TO REMOVE/REPLACE TETHER
To remove the tether connecting the side pod and base plate, compress the
tether spring hook at the side pod ① and pull the tether out from the slot ②.
To remove tether from the base plate, remove base plate from helmet. Pull
tether until it stops, then bend it toward the back of the base plate to release it
③ To reinstall, reverse the removal procedure.
TO REMOVE/REPLACE CHEEKPADS
When first servicing the cheekpads, it is suggested that you do only one at
a time so that the other can be used as a reinstallation guide.
To remove the cheekpads, first undo chinstrap.
Lift up the neckroll tab, which is inserted under the black covering at the
forward lower edge of the pad assembly.
Pull the pad toward the front of the helmet, then inward to release and slide
it off the strap.
To take off the fabric covering for washing, peel the covering off over the rear
edge of the cheekpad assembly until all the fabric is on the face side surface.
Then draw the covering through the opening by grasping the rectangular
collar and pulling.
To wash fabric coverings, put them into lukewarm water with small amount of
laundry soap or your own shampoo and wash gently by hand. Rinse well with
fresh water and wipe off with a soft cloth. Dry them in the shade at ambient
temperature.
Publicidad
Capítulos
