Tabla de contenido
Publicidad
CE compliance statement • FCC Part 15 compliance statement
CE compliance statement
We, the manufacturer of the Finwell PRO hereby declare compliance of Finwell PRO with the essential requirements in accordance
to the Directive 2014/53/EU of the European Parliament and of the Council of April 16th, 2014:
ETSI EN 300 328 (V2.1.1)
EN 62479 (2010)
ETSI EN 301 489-1 (V2.1.1)
ETSI EN 301 489-17 (3.1.1)
EN 61326 (2013)
EN 61010-1 (2010)
FCC Part 15 compliance statement • IC licence-exempt RSS compliance statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception which can be
determined by turning the equipment off and on, the user is encouraged to try to correct interference by one or more of the
following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Licence-Exempt Radio Apparatus
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Radio Frequency (RF) Exposure Compliance of Radio-communication Apparatus
This device complies with FCC and Industry Canada RF radiation exposure limits set forth for general population (uncontrolled
exposure). This device must not be collocated or operating in conjunction with any other antenna or transmitter.
Cet appareil est conforme aux limites FCC et Industry Canada concernant l'exposition aux rayonnements RF établies pour le grand
public. (Environnement non-contrôlé)
Cet émetteur ne doit pas être co-situé ou fonctionner conjointement avec une autre antenne ou un autre émetteur.
Changes or modifications not expressly approved by Water-i.d. GmbH could void the user's authority to operate the equipment.
FCC ID:
2ALRR-POOLLAB10
IC:
22610- POOLLAB10
Model:
POOL LAB 1.0
50
IC licence-exempt RSS compliance statement
Publicidad
Tabla de contenido
