Description Of The Appliance - CORBERO CCFW WC 999 S WD Manual Del Usuario

Connection to Power Supply
Connect the appliance power cord and plug to a properly earthed wall outlet. The required
nominal voltage and frequency are indicated on the rating plate (inside the unit or on the
exterior rear wall of the unit).
To Assemble Door Handle
To save shipping space and avoid damage of the
unit during transportation, the door handle of this
unit is shipped unassembled. Before putting the
unit into use you are kindly asked to assemble
the door handle as follows:
Locate the door handle and 2 screws attached inside
the cabinet, and prepare an appropriate screwdriver.
With the 2 screws attached, fasten the door handle
onto the frame of the door panel as illustrated. Be sure
that the screws must point to the holes on the frame of
the door panel when doing so.

DESCRIPTION OF THE APPLIANCE

Illustration of the Appliance
5. THERMOSTAT: For controlling the temperature inside
the wine cooler.
6. WOODEN SHELVES: Removable for easy
cleaning.
7. MAGNETIC GASKET: Tight fitting door seal keeps all
the cooling power locked inside. No hooks or latches.
8. TEMPERED GLASS DOOR: Allows easy
interior visibility.
Adjustable Wire Shelves
Shelves can be optionally placed on the guides inside the appliance where appropriate.
To remove a rack:
3. Remove all bottles from the rack.
4. Lift the rack upwards and then pull out.
To replace:
Put the sides of the rack back onto the supporting bar of the cabinet and push backward
until the rack tabs embeded into place. Note: Make sure the tabs on the rack are well
embeded in place before loading any bottles.
5