Operating The Unit - Belson BSA-1520 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PUTTING THE BATTERIES INTO THE REMOTE CONTROL UNIT
Press down
the compartment cover, and slide
the cover off to open the compartment. Place the
two (UM4), (AAA), (R03) batteries in the remote
control according to the polarity markings ("+" and
" - ") inside the compartment and on the batteries.
Place the cover over the compartment, press down
lightly, and push it upward until it snaps on.
NOTE : Remove the batteries from the remote
control if not in use for long period of the time.
Do not mix normal batteries with rechargeable
batteries, when the batteries become weak,
remote control will not function and replace with
new batteries.
INSTALLING THE SPEAKER WIRE
TO THE SPEAKER TERMINALS
1.
Speakers Connection
Extend the SPEAKER WIRES and con nect them
to the SPEAKER TERMINALS.
Power Cord Connection
2.
Before using , connect the AC Power Cord to
the AC outlet .then turn on the main switch of
the unit.

OPERATING THE UNIT

When you first plug the unit into the AC outlet , the unit will be in standby mode , You can
press the POWER/STANDBY button on the unit ( or on the remote control ) to switch the unit ON
and OFF. Pull the AC plug out of the wall socket if you want to switch off completely.
POWER/STANDBY
1.
Press POWER/STANDBY button on the unit (or remote) to switch the unit on.
2.
Select the sound source (CD , Tape , Aux, or Tuner) by pressing FUNCTION button.
The corresponding display will light up.
3.
Adjust the volume with the VOLUME (UP or DOWN) button.
4.
Set the preset equalizer ( pass, classic , rock , pop, or jazz) with the EQ button on the
Remote.
5.
Press POWER/STANDBY button again to turn off the unit.
UK-4

Publicidad

Tabla de contenido
loading

Tabla de contenido