Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GB
CONTENTS
Connections
Front of changer
Scanning CDs
INTRODUCTION
Thank you for selecting the NAD 515 Compact Disc
Changer.
The NAD 515 combines supreme playback quality
with a high degree of user-friendliness by offering the
following possibilities:
- changing CDs during play;
- quick access to a particular CD by means of
- storing 30 tracks from different CDs in any
desired order in the changer memory;
- storing the required recording time and playing
time in the EDIT mode.
NAD
4
NAD 515 COMPACT DISC PLAYER
INSTALLATION
4
POWER SUPPLY SETTING
• Check that the type plate on the rear of your
4
changer indicates the correct supply voltage.
• If your mains supply voltage is different, consult
your dealer or our Service Organisation.
5
SITING THE COMPACT DISC CHANGER
Free standing
• Always position the changer horizontally on a flat,
firm surface.
• Allow a free space of at least 3 cm above the
6
changer so as not to interfere with the cooling of the
changer.
Stacked
• Site the changer preferably at the bottom or at the
top.
• Never position the changer directly on top of a
high-power amplifier, as such an amplifier gives off a
substantial amount of heat.
FITTING A MAINS PLUG (U.K. only)
This apparatus is fitted with an approved moulded
8
13 Amp plug.
To change a fuse in this type of plug proceed as
follows:
• Remove fuse cover and fuse.
• Fix new fuse which should be a BS1362 5A,
9
A.S.T.A. or BSI approved type.
• Refit the fuse cover.
If the fitted plug is not suitable for your socket out-
10
lets, it should be cut off and an appropriate plug fitted
in its place.
If the mains plug contains a fuse, this should have
a value of 5A. If a plug without a fuse is used, the
11
fuse at the distribution board should not be greater
than 5A.
NOTE The severed plug must be disposed to avoid
a possible shock hazard should it be inserted into a
13A socket elsewhere.
HOW TO CONNECT A PLUG
The wires in the mains lead are coloured in accor-
dance with the following code:
BLUE - "NEUTRAL" ("N") and BROWN - "LIVE"
("L").
As these colours may not correspond with the
colour markings identifying the terminals in your plug,
proceed as follows:
• The BLUE wire must be connected to the terminal
which is marked with the letter "N" or coloured
BLACK.
• The BROWN wire must be connected to the ter-
minal which is marked with the letter "L" or coloured
RED.
Publicidad
Capítulos
Tabla de contenido
