Quick Setup - i.t.works SUNW2 Manual De Instrucciones

ENVIRONMENTAL RECEPTION EFFECTS
Your radio controlled weather station obtains the accurate time with wireless technology. Same as all
wireless devices, the receiving ability maybe affected by, but not limited to, the following
circumstances:-
•
Long transmitting distance
•
Nearby mountains and valleys
•
Among tall buildings
•
Near railway, high voltage cable etc.
•
Near road, airports, etc
•
Near construction sites
•
Inside concrete buildings
•
Near electrical appliances
•
Near computers and TV's
•
Wireless Broadband
•
Inside moving vehicles
•
Near metallic structures
Place your weather station at a location with optimal signal, i.e. close to a window and way from
metal surfaces or electrical appliances.
Viewing Angle
You must keep in mind that the LCD screen is constructed with an "optimum viewing angle". Your
eye level should be at around 60 degree to view the LCD screen correctly.

QUICK SETUP

Step 1:
Slide open the battery cover at the back of your weather station, insert 3 x AA batteries into the
battery compartment by observing the correct + / - polarity signs inside the battery compartment.
Replace the battery cover.
Step 2:
Keep your weather station and wireless transmitter next to each other. Slide open the battery cover at
the back of your wireless transmitter, then insert 2 x AAA batteries to the battery compartment.
Replace the battery cover.
Make sure CH1 (Channel 1) is displayed on the top of the outdoor temperature. You could press + /
CHANNEL to select Channel 1. Make sure CH1 (Channel1) is selected on the switch inside the
battery compartment of the transmitter. Replace the battery cover.
Your weather station will receive data signal from the transmitter after a short time.
Front
EN.4