Replacing Fuse - Dyna-Glo Pro KFA50H Manual Del Usuario

NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!

10. REPLACING FUSE

NOTICE : This heater is fuse protected.
If your heater fails to ignite, DO NOT RETURN YOUR HEATER TO THE
STORE.
Please follow the simple instructions below to inspect and change the fuse.
PROCEDURE FOR REPLACING FUSE
WARNING : SHOCK HAZARD
To prevent personal injury, unplug the power cord before replacing fuse.
1. Unplug heater.
2. Remove side cover screws using medium phillips screw driver.
3. Disconnect switch wires from power switch.
4. Remove fuse from fuse holder.(See Figure 21.)
5. Replace fuse.
WARNING : FIRE HAZARD
To avoid
6. Replace switch wires to power switch.
7. Replace side cover.
NOTE :
Screw
Side Cover
Power Switch
Do not substitute with a higher or lower current rating.
fuse rating : AC 125/8A
Switch Wire
Figure 21. Replacing Fuse
Fuse
KFA80H/135H/220H Models
Fuse
14
Fuse Holder
Fuse Holder
KFA50H