Securing A Private Network; Securing A Network Of Two Wifi Powerline Adapters; Leaving An Existing Powerline Adapter Network; Resetting Your Wifi Powerline Adapter - Essentiel Solo Instrucciones De Uso

securing a private network

The PAIR button allows you to set up a private 128-bit AES encrypted network without network
management software. If you want to encrypt all your WiFi powerline adapters into a single group or
if you cannot access other computers, you will need to use the appairage/réinitialisation (Pair/Reset)
button.

Securing a network of two WiFi powerline adapters.

Press and hold for one second the PAIR/RST button on the adapter located in Room A. The power
1.
indicator light flashes.
Within two minutes, press and hold for one second the PAIR/RST button on the adapter located in
2.
Room B. The indicator light flashes.
Wait one minute for pairing between the devices to finish. The power indicator light
3.
adapter connection indicator light will remain lit. The network is now secure.

Leaving an existing powerline adapter network

A powerline network works with at least two adapters. If you want to keep your powerline
network, only remove the additional adapters.
If you want to remove an adapter from the existing powerline network (to connect it to a new network,
for example), follow these steps:
Press the PAIR/RST button for 10 seconds on the adapter you want to remove from a network.
1.
The adapter will reset and the power indicator light
power indicator light will flash and then remain lit.
Wait until the adapter has fully rebooted.
2.
The adapter has left the existing powerline network and can be removed from the power outlet or
paired to a new network.
54
and the
will turn off. The adapter will then reboot, the

Resetting your WiFi powerline adapter

To perform this step, you will need a small, thin, rigid object (such as a paper clip).
!
Warning: The "Reset" function restores your WiFi powerline adapter to all its default
settings. It will therefore have the same settings as when you purchased it.
Insert the end of the small object into the hole next to the word "Reset", which is located underneath the
WiFi powerline adapter, until you feel a slight click.
Hold in place for 10 seconds.
The Reset procedure is initiated and restores your WiFi powerline adapter to its default settings. This
procedure may take several minutes.

frequently asked questions

Why is the speed rate of the WiFi 1200 powerline adapter not optimal?
Because of the master/slave structure, you should avoid plugging in two WiFi powerline adapters at
•
the same time; it is preferable to plug the WiFi powerline adapters into the power outlets one after
the other. Please unplug the WiFi powerline adapters and then plug them back in one after the other.
Check the network management software and recheck the speed rate.
The speed also depends on several factors. The distance to another WiFi powerline adapter,
•
interference with other devices and the number of WiFi powerline adapter sharing the same electrical
grid may influence the adapter's speed.
Can the WiFi powerline adapters be used in all types of housing?
Powerline adapter technology operates between an electrical phase and neutral.
In the case of a standard single-phase (2-pole) electrical installation, you can easily establish a
•
powerline network.
In the case of a three-phase (4-pole) electrical installation, the powerline technology will be difficult to
•
use and will require you to install additional equipment on your home's electrical network.
What is the operating distance of the powerline technology?
In theory, powerline technology works over distances of 200 to 300 meters without repetition. These
theoretical distances depend on the electrical structure and the network. In practice, 200 meters of
electrical cable without repetition is the maximum.
55