Data Setting; Function Of Remote - Accessmatic Viper 100 Manual De Usuario

5. Data setting

Close bu er speed: Distance increase clockwise Open bu er speed: Distance increase clockwise Open speed: Open speed increase
clockwise Close speed: Close speed increase clockwise Bu er speed: Bu er speed increase clockwise
Open hold time: Hold time increase clockwise (0-20s adjustable)
DIP switch: The selection of dip only make sense after restart system 1.E-LOCK: UP-Lock automatically Down-Lock by signal
2. Push and go: UP: Active Down: Disable
3. L/R switch: UP-right open Down-left open (Power on, in the default mode door move
to the close direction is correct, please change the position of Dip switch if door in open direction) 4. Master and slave: UP-Master drive,
Down-Slave drive
Button on the controller
Test: Test button, Press to active one open-close round
Learn: Remote setting button
LED Indicator
L1: Indicator of remote setting (Blue)
L2: Master drive indicator, led ash 1 time in 4second (Red) L3: Slave drive indicator, Led ash 1time in 4 second (Green)

6. Function of remote

FC04: A Always open B Automatic C: Open one time D Full lock
Add the remote: Keep press the learning button on controller, L1 Blue Led is on, release learn button
and press A on remote, Blue led ash 3 times, remote is added
Delete remote: Keep press the learning button 9 second, L1 turn from blue to ash, all the remote is
delete (attention: while the process of delete, learning button should keep press)
Wireless push button: Added and deleted wireless push button is same as remote. Please check the
DIP switch if it's same as the image shown (during setting process)
Opening your life
11