Assembly - Virtualfly TQ3 Manual De Usuario

2. ASSEMBLY

To obtain better user experience the device must be clamped on the
edge of the table. It can be done in two ways: On the table or protruding
from the table.
• Remove the two front rubber feet from the bottom of TQ3. (According
to Figure A of the assembly mounting.)
• Attach the clamping jaw (3) to the TQ3 with the screws (2) provided.
• Depending on which position you want to set the device on the table,
you can attach the clamping jaw to the bottom of device (Figure A) or
at the rear part (Figure B).
• Place the TQ3 on the table in a way that the clamping jaw can be fixed.
• Tighten the clamping jaw screw until the device stays firmly fixed.
Adjusting the lever's hardness
If you want you can adjust the lever's hardness tightening the wheel
located on the right side of the device.
Once you have adjusted the knob, move the 3 levers all the way at the
same time, from top to bottom, at least 10 times (D). This operation is
necessary to distribute adequately the same strength in the 3 levers.
TQ3 | User's guide