Power Saving Mode; Operation; Specification - Engel PL 2000 Manual De Usuario

2.4 Power Saving Mode

This HomePlug Ethernet Adapter can go into Power Saving Mode by pushing the Security Button for
4 ~ 9 seconds. When you would like to exit Power Saving Mode, simply just push the Security Button
for more than 0.5 seconds.

3. OPERATION

Operation is completely automatic, and no user intervention is required.
If your HomePlug devices have diffi culty communicating with each other, check the following:
· Try plugging the unit into an adjacent plug.
· Use a pin and hold the Reset Button down for two seconds on each unit you are trying to connect.
The unit lights should fl ash. Then units will then connect based off factory settings.
· Ethernet Transmitter through mains works better when plugged directly into the wall socket.
Connecting the Ethernet Transmitter through mains into the power strip or surge protectors may
degrade the network performance.

4. SPECIFICATION

Powerline Standards
PHY Rate
Modulation
Main Chipset
Protocol
Security
LEDs
Ethernet Interface
Ethernet Standards
Power
Power Consumption
Operating Temperature
Storage Temperature
Operating Humidity
HomePlug AV
Up to 200 Mbps
1024/256/64/16/8 QAM, QPSK, BPSK, ROBO Carrier Modulation
Gigle GGL301
TDMA, CSMA/CA
128-bit AES Encryption
Power: on / off
PLC link: red / orange / green / off
Ethernet link: solid / blinking / off
1 * RJ45 LAN Port
Auto-negotiation, Auto MDI/MDIX
Ethernet specifi cation IEEE802.3, IEEE802.3u, IEEE802.3x
100 - 240VAC, 50/60 Hz
100mA (max.)
0° C to 40° C
-20° C to 70° C
10-90%RH (max)
- 10 -