Accessmatic Viper 200 Manual De Usuario página 46

Opening your life
7.Wired Diagram
Operation of remote control
A: Always open
B: Automatic
C: Open and close one time
D: Full lock
Add remote:
1. Keep pressing the learning button LEARN, release the button a till LED become red， then press any button on remote ， remote will
been added after led ash and buzzer rings.
2.Keep pressing any button on remote ， and keep pressing button LEARN on remote at same time， release button LEARN till LED
become red， remote will been added after led ash and buzzer rings
Delet remote ：
Keep pressing learning button A 5 seconds， all remote memory will delete after LED ash 3 times （Tip ： Ensure keep pressing learning
button when delet remote memory） .
Please check the DIP switch if it' shown （ during setting process） as same as the image Function selection of wireless push button （ work
with swing door） .
1.Remove battery
2.Keep pressing "Reset" button
3.Insert the battery at same time， the red led ash
4.Keep pressing button A ， red led o about 5 second， Then ash again
5.Release Reset button and A button， Setting is done
*Importance ： the "Reset" button keeps pressed till the whole setting nishes.
Notes:
1.Receiver has been built-in.
2.Exit only function: Connect outside sensor or button to terminal"Open-B", connect inside sensor or button to terminal "Open-A". Then
press "full lock" button on remote.
3.When double open, Synchronous cable must be connect refer to manual.Power on， Ensure the setting on both controller is same.If
speed is di erent during operating ,Pls slightly adjust open /close speed, open/close barking speed,opening time.
4.When double open, remote control must learn both controller ， in order to control two door at same time
5.In double open mode， accessories should connect to both controller （ parallel connection）
20