König SEC-PCC10 Manual De Uso página 3

Watch Dog Connection
The Watch Dog Connection will allow the card to reboot the PC automatically when it
detects problems with the PC.
A) Connect the reset cable, which is connected with the mother board, with the Watch
dog connection of the card.
B) Connect the supplied cable with the jumpers on the mother board and the Watchdog
connection of the card.
See below fi gure:
Watch Dog
4. Replace the PC's cover and power cord and reboot the system.
5. When the Windows System reboots, the "New Hardware Wizard" dialog will appear.
Ignore the dialogue.
Note: In Windows XP the dialog will disappear after driver installation. In Windows
2000, you will need to close the dialogue manually.
6. Put the Installation CD into the CD-ROM. The Auto-run page will be displayed. Click
on "DVR SYSTEM INSTALL" and then the "DRIVER INSTALL" to automatically
install the driver.
DVR software installation
After the driver has been installed, click "DVR SYSTEM" on the Auto-run page to install
the DVR software.
Note: The fi rst time the DVR software runs, the default user account: "Administrator"
and password "1234" needs to be used to log in to the DVR System.
For further details on using the PCI security card, refer to advanced manual supplied
on CD.
A. PC Reset Button
A. PC reset cable
B. Supplied
Watch
Dog cable
3
B. Jumpers on
Mother Board