Fault Localisation, Troubleshooting; Customer Service / Support; De-Commissioning - ABNOX Standard Manual De Instrucciones

EN

Fault Localisation, Troubleshooting

CAUTION
Remediation of any of the faults
described below may only be
carried out by a trained technician.
Fault
Lubricant pump does not start
Lubricant pump runs but does
not convey lubricant
Pump generates little to no
medium pressure

Customer Service / Support

ABNOX AG
Langackerstrasse 25
CH-6330 Cham
Switzerland
Tel. +41 (0) 41 780 44 55
Fax +41 (0) 41 780 44 50
E-Mail info@abnox.com
Internet www.abnox.com
20
Possible cause
Not connected to compressed air
supply
No pressure in the compressed air
network
Defective switching mechanism
No lubricant in the area of the
suction valve
Pump start with excessively high
air pressure
Seal on suction valve damaged
Air pockets
Leakage

De-Commissioning

Brief Interruptions:
In the event of short interruptions (overnight or just
over the weekend), shut down the product. The
system must be de-pressurised.
Long-Term Interruptions:
In the event of a longer-term interruption (more than
three days), the following points should be observed:
• The main switch must be shut down
• The system must be de-pressurised (check the
displays)
Resolution
Connect to compressed air supply
Increase pressure to 2-10 bar
Must be repaired by a specialist
Pre-fill suction valve with grease
Ensure that there is lubricant in the
area of the suction valve
Start pumping with low air pressure
and gradually increase to desired air
pressure
Replace seals
System entlüften
Inspect fittings and hoses for
damage, repair if needed
CAUTION
Risk of accident and danger to the
environment:
Grease / oil on the ground increase
the risk of accident.
The grease/oil must be properly
disposed of in compliance with
applicable national ordinances
(hazardous waste).