MOWIN MCU Manual De Instrucciones página 25

D) SUN SENSOR (Sun control movement inversion)
The control unit is supplied by the manufacturer with a Sun Control = Down command association, that is to
say when the Sun sensor detects sunlight, the control unit sends a command for downward movement. If you
want the control unit to send a command for upward movement when sunlight is detected by the Sun Sensor,
proceed as follows: check that the extended menu is enabled (SUN and RAIN LEDs flash alternately), use the
"SEL" button to navigate to SUN SENSOR LED when flashing and press the "SET" button: the SUN SENSOR
LED lights up and programming is complete. Repeat the procedure to restore the previous configuration.
E) RAIN SENSOR (Rain command movement inversion)
The control unit is supplied by the manufacturer with a Rain Control = Up command association, that is to say
when the Rain sensor detects rain, the control unit sends a command for upward movement. If you want the
control unit to send a command for downward movement when rain is detected by the Rain sensor, proceed
as follows: check that the extended menu is enabled (SUN and RAIN LEDs flash), use the "SEL" button to
navigate to RAIN SENSOR LED when flashing and press the "SET" button: the RAIN SENSOR LED lights up
and programming is complete. Repeat the procedure to restore the previous configuration.
RESET
To reset the default configuration of the control unit, press the SEL and SET buttons simultaneously; all indi-
cator LEDs will switch on and then off again immediatel.
11