Publicidad
Idiomas disponibles
Idiomas disponibles
Wireless collar / key
chain sensor
(Ref. 8131)
ENG – User Manual
abb
abb
abb
abb
1.- Technical data
Battery: CR2032
RF channels: 1 wireless sensor (transmitter) channel. Switch ON type.
Radio frequency: 868 MHz
Range:
Approx. 30m inside buildings. 100m free field space conditions.
Operation temperature: 0 - 45ºC.
2.- Configuration
2.1.- Wireless key chain sensor view
Selector switch:
Programming mode
Operation mode
2.2.- Link configuration
1.
1.
Set the wireless switch actuator (receiver), which we would like to link
to the wireless key chain sensor, in programming mode.
2.
At the wireless key chain sensor: (a) move the selector switch to
"programming mode" position and (b) press the push button.
3.
If the link process is successful and the RF key chain has correctly
learned the actuator linked, LED at the wireless key chain sensor
lights continuous red for 3 seconds.
If programming fails during link process, the LED at wireless key
chain sensor briefly flashes three times, indicating it has not learned
any actuator. Please, repeat the sequence from point 1.
Note: To assure the wireless key chain sensor is well working with the actuator,
the link configuration process should be successfully done. The LED at the
wireless key chain sensor should light continuous red for 3 seconds at the end of
the linking process.
Red LED
Push button
3.- Operation
Important:
In operation mode, the selector switch of the LED at the wireless
key chain sensor should be at "operation mode" position.
Help warning operation
Every time the RF key chain is pressed, it will start a sequence of sending ON
actuation telegrams to the actuator linked.
-
If the actuator (receiver) confirms the wireless key chain sensor the
reception of the ON telegram sent by the the wireless key chain sensor, it
will stop sending ON telegrams and it will lights for 3 seconds the red LED.
-
If the actuator (Receiver) does not confirm the wireless key chain sensor
the reception of the telegram sent by the wireless key chain sensor, it will
repeat sending the ON telegram every 10s during 5 minutes, until it
receives the acknowledgement of reception from the actuator linked. Every
telegram is sent, red LED will shortly flash once.
When battery is low and RF key chain is pressed, red LED light flashes briefly 3
times each time an ON RF telegram is sent. Please, change battery as soon as
possible.
4.- Battery replacement
1.
To access the battery, remove the screw of the housing.
2.
Remove battery from the battery holder helped by an
screwdriver
3.
Insert a new battery
Publicidad
