Important Safeguards - Pool Blaster LEAF VACUUM Manual De Uso

For Bottom Cleaning
Press the ON/OFF button on the battery box to start the Leaf
Vac. Using the pool pole, lift the Leaf Vac into the pool and
guide it to the pool bottom in the "Wheels Down" position.
For Surface Cleaning
Push the pole adapter down
until the adapter locks in place.
Turn the cleaner "ON."
The Leaf Vac may now be used
in the "Wheels Up" position to
skim leaves and other floating
debris from the pool's surface.
Adjusting the Clearance Height
The Leaf Vac is packaged
with its clearance height in the
"LOW" position.
The height of the Leaf Vac
can be raised up to 1/4 inch if
needed by doing the following:
1. Use a small scewdriver or
pair of needle-nose pliers to
remove the "E"-clip from the
top of the wheel pivot shaft.
2. Remove the wheel pivot
shaft assembly. Don't lose the
"E" - clip and spacer.
(see Photo).
3. Place the spacer on the
pivot shaft and guide the
shaft back into the body from
beneath.
4. Replace the "E"-clip on the
top of the shaft.
Repeat these procedures on
the remaining 2 wheel pivot
assemblies.
USING THE POOL BLASTER LEAF VAC
4
Maintenance
ALWAYS clean out the debris bag following each use and
carefully remove any debris that might be stuck in the propel-
ler area of the cleaner.
Remove the batteries from the battery box prior to long-term
storage (ie. at the end of the pool season).

IMPORTANT SAFEGUARDS

1. Extreme care must be taken to avoid fingers,
toes, hair or any other body part from coming in
contact with the Impeller while the unit is
operating.
2. Operation of this unit by children and/or
persons of diminished physical or mental
capacity is not recommended unless they are
closely supervised by an authorized adult.
3. Always check the battery box cap to make
sure that it is completely closed before each
use. If water enters the battery box, it can
damage the unit but is not considered a health
hazard.
Pole Adapter Assembly
LVAC061
Battery Chamber Assembly
LVAC015
Filter Bag
LVAC022AP
Filter Ring
LVAC056
Leaf Vac Body
LVAC100
Wheel Assembly
LVAC050