BITO FallPROtect Manual De Instrucciones página 8

1.3 Assembly
The anchor point (BITO-easyHOOK) is connected to the rack strut as shown in figures 1-5. Connect the component with the hole to the twist
lock carabiner with the automatic safety device (twist lock) (see figure 4). Ensure that the twist lock carabiner is fully locked. Check and
double-check that the anchor point cannot be detached from the rack strut again.
The anchor device can now be used as a catching device together with the fall arrestor and the body harness (figure 5).
To disassemble the system, follow the instructions in reverse.
Anchor point (BITO easyHook)
1
4
8
Twist-lock carabiner
2
5
GB
1x
1x
3