ZKX Audio KW895 Manual Del Usuario página 9

TRUE DIVERSITY RECEIVER
True diversity receiver is shown in picture. Take out the receiver and the receive antennas from packing box
;place the receiver near the performance area (stage), mounting the antennas to the receiver. Point the
antennas upward. Make sure, that the transmitter (microphone) will never get any closer to the receiver than
10 ft. (3m), optimum separation is 16 ft. (5m). There shoukd always be a sirect line of sight between the
microphone and receiver. Place the receiver least 5 ft. (l.5m) away from any big metal objects, walls, scaffoding,
ceilings, etc.
ANTENNA
POWER BUTTON
Connect BALANCED OUTPUT in receiver and MIC INPUT in the amplifier with the supplied unbalanced audio
cable. The Balanced socket (BALANCED) specializes in connecting sound stage with the optional balanced
audio cable. Do not use the Balanced and Unbalanced Sockets simultaneously!
This may cause sgnalloss or increase noise. Check if the AC voltage stated on the rear panel of the receiver
matches the AC electric socket in the wall before connecting the power cable in Receiver. Otherwise way cause
irreparable damage to the unit. Adjust the volume of the receiver and amplifier to "MIN" and turn on the receiver,
the LCD screen of the receiverwill light on and display as picture.
RF SIGNAL
AF SIGNAL
CHANNEL
Make sure the frequency or the channel of the receiver are same to the microphones. Turn on a microphone, the
"MUTE" will disappear, and the There for signal will be displayed. When you speak to the microphone, the AF
signal will be displayed. ln the same time, one of the diversity indicator "A" or "B" will be displayed, lf the " A
appear means the inner receiver A get signal while the B works if the "B" Appear. Moving the microphone, the
one of the "A" and "B" will be selected to appear automatically according to the better signal, This means the
diversity circuit is working to eliminating the bling area.
Set the VOLUME to get proper volume without feedback.
To change receive frequency (channel), press the SET key first, the "CH" in the LCD screen. will flash, you can
change the receive frequency of microphine by press UP key or Down key. Press the SET key again, for exit.
MUTING SELECTING
Press the SET key in a few second ,the screen will become showing "SQL-95".
Then press the "UP" or "Down" button to adjust for getting the receiving intensity that you need.
LCD SCREEN
SCREEN OF RECEIVER
5 10 15 20 25 30 35
RF
AF
808.700
-30 -25 -20 -15 -10 -5 0
CH
016
- page 4 -
USER`S MANUAL KW895
VOLUME KNOB
BUTTONS
40
A B DIVERSITY INDICATOR
PEAK
MUTE INDICATOR
MUTE
FREQUENCY
MHz
4