Cleaning And Storage - Ciatronic BS 1238 Instrucciones De Servicio

5....-05-BS 1238 Neu
Filter:
GB
Your appliance has two filters.
Motor protection filter (inlet filter):
The inlet filter is located in the dust bag compartment. The filter is located vertically
in the rear section of the dust housing. Remove the filter by pulling upwards. Clean
the engine protection filter after 10 dust bag changes. If necessary, the filter can
also be washed in warm water without any additives. Place it back into place only
once it is completely dry!
Outlet filter:
The appliance is also equipped with an outlet filter. This filter is to be found on the
side of your device behind the ventilation grille.
Open the ventilation grid by pulling the lever next to it. Then pull the grille out
towards the front. Remove the filter and clean as described above. Please reinsert
the filter correctly and then close the ventilation grille.
Cleaning
• Pull the plug out of the socket before cleaning!
• Clean the casing with a dry cloth.
Storage
• Let the iron cool down completely.
• Wind the cable completely.
• Position the device either horizontally or vertically in order to suspend the hook
on the floor nozzle in the parking assistance on the rear or the bottom of the
device.
This device has been tested according to all relevant current CE guidelines,
such as electromagnetic compatibility and low voltage directives, and has been
constructed in accordance with the latest safety regulations.
Subject to technical changes without prior notice!
42
14.09.2004

Cleaning and storage

8:33 Uhr Seite 42