Mains Connection - Gude ESS 350 Traducción Del Manual Original

ENGLISH
8
CE marking
Any damaged or disposed electric or
electronic devices must be delivered to
appropriate collection centres.
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fi re and/or
serious injury.
Save all warnings and instructions for future
reference.
Safety information for impact
wrenches
Hold power tool by insulated gripping surfaces,
when performing an operation where the fastener
may contact hidden wiring or its own cord.
Fasteners contacting a „live" wire may make exposed
metal parts of the power tool „live" and could give the
operator an electric shock.
Additional Safety and Working
Instructions
Wear ear protectors. Exposure to noise can cause
hearing loss.
Use protective equipment. Always wear safety
glasses when working with the machine. The use of
protective clothing is recommended, such as dust
mask, protective gloves, sturdy non-slip footwear
and ear defenders.
The dust produced when using this tool may be
harmful to health. Do not inhale the dust. Wear a
suitable dust protection mask.
Clamp your workpiece with a clamping device.
Unclamped workpieces can cause severe injury and
damage.
Check all screw and plug-in connections and
protective equipment if fi rm and tightened
properly and whether all moving parts are
running smooth whenever the appliance is to be
put into operation.
The appliance must not be used if damaged
or safety equipment is defective. Replace any
worn-out and damaged parts.
Do not use the device near fl ammable liquids or
gases. Risk of fi re and explosion in case of short
circuit.
Always keep the connection cable from the working
area of the device. Always guide the cable back-
wards, away from the device!
58120-ESS350_Schlagschrauber_1-0.indd 8
Please turn the device immediately off when the
tool used gets blocked! Do not turn the device on
again when the tool is still blocked. This could cause
bounce back with a high reaction moment. Deter-
mine and remove the cause of the blocking of the
tool used while respecting the safety instructions.
The possible causes may be:
• it is tilted in the workpiece to be machined
• it has pierced through the material to be machined
• the power tool is overloaded

Mains Connection

Operation is only allowed with a safety
switch against stray current (RCD max. stray
current of 30mA).
Connect only to single-phase AC system voltage as
indicated on the rating plate. It is also possible to
connect to sockets without an earthing contact as
the design conforms to safety class II.
Only plug-in when machine is switched off .
Maintenance
Unplug the machine before any work on it.
Repairs and works specifi ed in these Instructions may
only be performed by qualifi ed authorised staff .
Use only original accessories and original spare parts.
Keep the device, in particular the air vents, clean at all
times. Never spray water on the device body!
Do not clean the plastics with solvents, fl ammable or
toxic fl uids. For cleaning, use a damp cloth only.
Caution! If the power cord of the appliance gets
damaged, it must be replaced by the manufacturer or
its customer service or a similarly qualifi ed person to
avoid danger.
Only a regularly maintained and treated appliance
can serve as a satisfactory aid. Insuffi cient mainte-
nance and care can lead to unforeseen accidents and
injuries.
If necessary, a list of spare parts can be found at www.
guede.com.
27.04.15 17:01